Welcome, Guest. Please Login.
YaBB - Yet another Bulletin Board
07/22/19 at 20:36:18
News: YaBB is sponsored by XIMinc!
Home Help Search Login


Pages: 1
Send Topic Print
Why shafts get bent ? (Read 3779 times)
HNGOHEL
RSA Newbies
*


Forum member

Posts: 12
Why shafts get bent ?
09/17/07 at 07:37:48
 
It has been observed that shaft get bent for various rotating equipments like pumps, gearboxes etc. Shaft bending of a agitator is quite obvious, dry running or inadeqaute liquid level.
 
What precautions are required ?
Regards
HN Gohel
Back to top
 
 
Email View Profile   IP Logged
Rolly Angeles
Rolly Angeles
*****


moderator

Posts: 60
Gender: male
Re: Why shafts get bent ?
Reply #1 - 09/29/07 at 20:35:26
 
Dear Hasmukh,
 
It is very difficult to speculate why your shafts bend unless we can perform a thorough Failure Analysis on the bent shaft.  If there is some form of deformation, then consider heat to be a factor.  Consideer also alignment practices.  This is all I can contribute for now.
 
My warm regards,
Back to top
 
 

Rolly Angeles
www.rsareliability.com
View Profile WWW   IP Logged
Pages: 1
Send Topic Print